Resin Heat Tool

Use the Resin Craft by Me™ heat tool to quickly remove bubbles from resin. The heat tool is also helpful for moving uncured resin around in projects.

Directions:

1. Plug in the heat tool and turn on. Allow to warm up for approximately 10 seconds.
2. To pop bubbles, wave the heat gun approximately 2 inches from the surface of the resin until the heat forces the bubbles to pop.

Caution: Do not use near water. Dry location only.

The heating temperature of this heat gun can reach up to 392°F (200°C).

WARNING: Not intended for children age 12 and under.

The maximum time of single use should not exceed 3 minutes. Specifications: Temperature 392°F (200°C) Watts 300, Amps 2.5, Volts 120V 

• Made in China

• Weight: 4 oz (113.4 g)

• SKU: R2304220124

• GTIN: 842702198049